flocculation reaction
英
美
絮凝反应
双语例句
- The flocculation mechanism of PACSAM is chemical reaction, intermolecular hydrogen bonding, charge neutralization and bridging action, etc.
PACSAM的絮凝机理包括化学反应、分子间氢键、电中和及架桥作用等。 - The reaction mechanism in the electrochemical treatment system has also been explored preliminarily. It was regarded that the treatment was the combination process of adsorption, radical polymerization and flocculation reaction.
初步探讨了该电化学处理系统的反应机理，推论整个处理为吸附、自由基聚合和絮凝反应相结合的过程。 - Optimun Model for Flocculation Reaction Kinetics in Water Treatment
水处理絮凝反应动力学优化模型 - It also exhibits a good effect on the removal of COD, SS and TP of waste water and the removal rate of those are 70%, 73% and 92%, which depend on diatomites absorption, flocculation and filtration and partly biological reaction.
而对COD、SS和TP的去除，依靠改性硅藻土的吸附、絮凝、过滤和部分生物作用，去除率分别可以达到70%、73%和92%。 - The treatment effect was optimal when the flocculation reaction time was 12 minutes.
絮凝反应时间12min效果最佳； - Simulated wastewater of Reactive Turquoise Blue KN-G was treated by rotating electrochemical disc/ electrolytic flocculation process. Voltage, rotating speed, pH value and reacting time that most influenced the color and TOC removal were studied, and the optimum reaction conditions were also confirmed.
采用一种新的电化学方法&电化学转盘/电凝聚法来处理模拟活性翠蓝KN-G废水，考察了电压、转速、pH、反应时间对色度、TOC去除率的影响，并确定了最佳反应条件。 - After checking, the model simulation value and measured value is on a wide range of match, the result shows that the model can better response biological flocculation adsorption-biological aerated filters in the process of the reaction process, it is credible.
校核后的模型的模拟值与实测值在较大范围内相吻合，说明该模型能较好的反应生物絮凝吸附-曝气生物滤池工艺中的各种反应过程，是较可信的。 - Part of the properties and application of y-PGA: y-PGA can occurs flocculation reaction with most metal ions, especially for Cr3+, Fe3+, Cu2+ the flocculation effect is particularly evident.
γ-PGA的部分性质及应用试验，结果表明：γ-PGA可与多数金属离子发生絮凝反应，特别是对Cr3+、Cu2+和Fe3+，絮凝效果特别明显。 - Moreover, the votex shear force should be controlled especially during the evening of flocculation reaction, in order to weaken the breakage of flocs.
另外，絮凝过程中还需要有效地控制涡旋剪切力，减小其对絮体的破坏，尤其是在反应后期絮体粒径较大时更应注意。 - Through the sensitivity analysis to the biological flocculation adsorption-biological aerated filters technology model, we found in these parameters, biological membrane surface area, film thickness and some reaction kinetics parameters is of high sensitivity, and others are lower.
通过对生物絮凝吸附-曝气生物滤池工艺一维模型进行灵敏度分析，发现出水水质对生物膜表面积、膜厚和一些反应动力学参数的灵敏度较高，而对其他的则都较低。